Samsung DVD-CM250H/XEF, DVD-CM250H/XEU manual Tuning Your Television for the DVD-VCR

Tuning Your Television for the DVD-VCR

You must tune your television for the DVD-VCR only if you are not using a Scart cable

GB

2

4

➢To view pictures from your DVD-VCR when a Scart cable is used, the television must be set to the audio/video mode (AV).

1Switch on the television.

2Switch on the DVD-VCR by pressing STANDBY/ON on the front of the DVD-VCR or STANDBY/ON on the remote control.

3Select a programme position on the television to be reserved for use with your DVD-VCR.

4Insert the video cassette in the DVD-VCR. Check that the DVD-VCR starts reading the cassette; if not, press ❿II button.

5Start a scan on your television or set the television to UHF channel 36.

6Fine tune the television until the pictures and sound are obtained clearly.

7If you cannot find the pictures and sound, or there is interference from nearby channels, it may be necessary to change the setting of the DVD-VCR output channel (see Setting the DVD-VCR Output Channel on page 23 and Problems and Solutions on page 72).

8When the picture and sound are perfectly clear, store this channel at the desired programme position on the television. Result: That programme is now reserved for use with your

DVD-VCR.

14