Samsung DVD-CM250H/XEU, DVD-CM250H/XEF manual Connecting DVD-VCR to the TV using the Coaxial Cable

Connecting DVD-VCR to the TV using the Coaxial Cable

To receive television programmes a signal must be received from one of the following sources:

◆An outdoor aerial

◆An indoor aerial

◆A cable television network

◆A satellite receiver

☛Make sure that both the television and the DVD-VCR are switched off before connecting the cables.

1Remove the aerial or network input cable from the television.

2Connect this cable to the 75Ω coaxial socket marked on the rear of your DVD-VCR.

3	Plug the coaxial cable supplied into the TV socket on your
	DVD-VCR.

4Plug the other end of the coaxial cable into the connector previously used for the aerial on the television.

5To obtain better pictures and sound quality on your television, you can also connect your DVD-VCR to the television via the SCART cable (see section below) if your television is equipped with this type of connection.

DVD & VCR	AUX
	AUDIO
	IN	OUT
RADIO ANT.	R
	L	GB
2
	VIDEO

TV	DVD & VCR	AUX
		AUDIO
	IN	OUT
	RADIO ANT.	R
	FM
	75	L
	COAXIAL
	AM
	4	VIDEO
	3

Connecting DVD-VCR to the TV using the SCART Cable

Aerial
TV
DVD & VCR	AUX
	AUDIO
IN	OUT
RADIO ANT.	R
FM
75	L
COAXIAL	2
AM
3	VIDEO
SCART Cable
RF coaxial cable

You can connect your DVD-VCR to the television using the SCART cable if the appropriate input is available on the television. You thus:

◆Obtain better quality sound and pictures

◆Simplify the setting up procedure of your DVD-VCR

☛◆ Regardless of the type of connection chosen, you must always connect the coaxial cable supplied. Otherwise, no picture will be visible on the screen when the DVD-VCR is switched off.

◆Make sure that both the television and the DVD-VCR are switched off before connecting the cables.

1Connect the coaxial cable as indicated in the above section.

2Connect one end of the SCART cable to the AV1 (EURO AV) socket on the rear of the DVD-VCR.

3Plug the other end into the appropriate connector on the television.

11