Samsung DVD-V80 Tuning Your Television for the DVD-VCR Deck Control Keys, STANDBY/ON Button

Tuning Your Television for the DVD-VCR

Deck Control Keys

GB	STANDBY/ON	OPEN/CLOSE
		2

4

You must tune your television for the DVD-VCR only if you are not using a RCA cable

➢To view pictures from your DVD-VCR when a RCA cable is used, the television must be set to the audio/video mode (AV).

1Switch on the television.

2Switch on the DVD-VCR by pressing STANDBY/ON on the front of the DVD-VCR or STANDBY/ON on the remote control.

3Select a programme position on the television to be reserved for use with your DVD-VCR.

4Insert the video cassette in the DVD-VCR. Check that the DVD-VCR starts reading the cassette; if not, press ❿II button.

5Start a scan on your television or set the television to UHF channel 36 (Australia:UHF 38 CH).

6Fine tune the television until the pictures and sound are obtained clearly.

7If you cannot find the pictures and sound, or there is interference from nearby channels, it may be necessary to change the setting of the DVD-VCR output channel (see Setting the DVD-VCR Output Channel on page 25 and Problems and Solutions on page 69).

8When the picture and sound are perfectly clear, store this channel at the desired programme position on the television.

Result: That programme is now reserved for use with your DVD-VCR.

The DVD-VCR uses one set of controls to operate both decks. The following keys are helpful in successfully controlling each deck.

1STANDBY/ON Button

Press the STANDBY/ON button on the remote control or front panel to turn on the DVD-VCR.

2DVD Button

Press the DVD button on the remote control when you want to control the DVD deck.

◆The DVD indicator will light on the Front Panel Display to show that the DVD deck is selected.

3VCR Button

Press the VCR button on remote control when you want to control the VCR deck.

◆The VCR indicator will light on the Front Panel Display to show that VHS deck is selected.

4INPUT SEL. BUTTON

Press the INPUT SEL. button repeatedly to cycle through all of your input sources, including the Tuner (PR##), Line 1 (rear AV input), and Line 2 (front AV input).

•Input select is only available when the VCR deck is selected.

➢Before using the VCR operation of 21~47 pages, press the VCR button on the remote control to select VCR mode.

Before using the DVD operation of 48~67 pages, press the DVD button on the remote control to select and watch DVD.

GB

STANDBY/ON

STANDBY/ON

1 1

2 3

4

16 17