Remote Control Buttons
Remote
Control
ŒPOWER button
´ASPECT button
ˇNumber buttons ¨+100 button
Press to select channels over 100. For example, to select channel 121, press “+100”, then press “2” and “1.”
ˆMUTE button
ØVOL (Volume) buttons ∏SLEEP button
”MENU button ’ENTER button
˝PIP button
ÔSTILL button LED Display
When you press a button, ‘
‘ appears along with selected mode (TV, CATV, DVD or STB) and remaining batteries on LED.
ÒP.MODE button
Adjust the PDP picture by selecting one of the preset factory settings (or select your personal, customized picture settings.)
ÚMODE button
Selects a target device to be controlled by the Samsung remote control (ie., VCR, Cable, DVD players or STB). If you change modes, the new mode is momentarily displayed on LED.
Æ
Tunes to the previous channel.
ıTV/VIDEO button
Press to display all of the available video sources
(ie., Video,
˜CH (Channel) buttons
Use it to switch channels.
¯INFO button
Press to display information on the PDP screen.
˘EXIT button
Press to exit the menu.
¿Up/Down Left/Right buttons
12Control the cursor in the menu.
¸SURROUND button
Press the hear the Dolby surround effect.
˛MTS button
Press to choose stereo, mono or Separate Audio Pro- gram (SAP broadcast).
◊AUTO PROG. button
The TV automatically cycles through all of the avail- able channels and stores them in memory.
±ADD/DEL button
Press to add or delete channels in the TV’s memory.
≠DNIe button
Activates DNIe (Digital Natural Image engine).
Controls the caption decoder.
—SET button
Used during set up of this Samsung remote control, so that it will work compatibly with other devices (VCR, cable box, DVD)
÷PIP control buttons
SWAP | : Exchanges the video signal that is currently |
| displayed on the main screen with the |
| signal in the PIP window. |
SIZE | : Press to make the PIP window Large, Small |
| or Double. |
CH▲,▼ : Displays the available channels in sequence. (These buttons change channels in the PIP window only).
®VCR, DVD control buttons
Controls VCR tape or DVD disc functions: Stop,
Rewind, Play/Pause, Fast Forward.
∑RESET button
If your remote control is not functioning properly, take out the batteries and press the reset button for about 2~3 seconds.
Installing the Batteries in Your Remote Control
Slide the back cover | Install two AAA size batter- | Slide the cover back into |
1to open the battery | 2ies. Make sure to match the | 3place. |
compartment of the | “+” and |
|
remote control. | teries with the diagram |
|
| inside the compartment. |
|
Remote Control Operation Range.
You can use your remote control within a distance of 23 feet and an angle of 30 degrees
from the left and right sides of the PDP’s remote control receiver. | 13 |
