English-8
Connecting Cable TV

To connect to a cable TV system, follow the instructions below.

Cable without a Cable Box

1
Plug the incoming
cable into the
ANT1 IN(CABLE)
terminal on the
back of the TV.

Because this TV is cable-ready,

you do not need a cable box to

view unscrambled cable channels.

2
Plug the combiner
into the ANT2 IN
(AIR) terminal on
the bottom of the
rear panel.

Antennas with 75-ohm Round Leads

1
Plug the antenna
lead into the ANT 2 IN
(AIR) terminal on the
bottom of the
back panel.

Separate VHF and UHF Antennas

If you have two separate antennas for your TV (one VHF and one UHF), you must

combine the two antenna signals before connecting the antennas to the TV. This

procedure requires an optional combiner-adaptor (available at most electronics shops).

1
Connect both antenna
leads to the combiner.
CONNECTIONS
ANT2 IN
(AIR)
UHF
VHF
ANT2 IN
(AIR)
UHF
VHF
ANT1 IN
(CABLE)
01 BN68-00929A-00Eng.qxd 6/13/05 2:01 PM Page 8