Samsung LN40A620A1F, LN2A620A1F Connecting the RJPRemote Jack Pack,  RJP Remote Jack Pack

Connecting the RJP(Remote Jack Pack)

➣This function is only available when the TV is installed in a hotel.

	3	S-Video / Audio Cable
		2	Video / Audio Cable	TV Rear Panel
	or			TV Side Panel
RJP Rear
			5
			1 D-sub / PC Audio cable
4	HDMI cable

Output of any external source connected to RJP on hotel desk.

1.Connect the PC IN [PC] / [AUDIO] port of the TV to the PC/AUDIO port of the RJP.

2.Connect the AV IN [VIDEO]/[R-AUDIO-L] port of the TV to the RCA port of the RJP.

3.Connect the S-VIDEO / AV IN[R-AUDIO-L] port of the TV to the S-VIDEO port of the RJP.

➣You cannot connect and use the AV and S-VIDEO ports at the same time.

4.Connect the [HDMI] port of the TV and the HDMI port of the RJP.

5.Connect the EX-LINK port of the TV and the RS/232 port of the RJP.

➣The RJP (Remote Jack Pack) compatible with this Samsung TV is TeleAdapt TA-7610.

RJP (Remote Jack Pack)

RJP stands for Remote Jack Pack. The RJP is a hardware module that has different Audio Video inputs (A/V, S-Video, Audio, PC and HDMI) and corresponding outputs. The corresponding output sources are connected from RJP to

TV. The RJP communicates with the TV via RS232. Hot Plug & Play is a function that allows hotel guests to connect an external source to the RJP. The RJP communicates with the TV by sending messages regarding Active/Inactive sources. The TV will switch to the Active external source according to the priority set by the User.

➣You have to connect the HDMI of the RJP to the HDMI 1 port of the TV.

➣When the TV is on, connect the TV and the RJP within 10 seconds.

➣Some HDMI Cables may not support RJP Function because RJP HDMI input impedance is high. If the connected HDMI device is not displayed, check whether or not the HDMI cable is properly connected or change the HDMI Cable.

The RJP can be returned to the factory default settings by pressing the A/V and HDMI buttons simultaneously for 10 seconds. All LEDs blink 5 times to acknowledge that the rest has been performed.

The RJP will automatically turn off any LEDs after 5 minutes to avoid unnecessary light pollution in the hotel room. The LEDs that were turned off will turn on again if the guest touches any of the buttons and the 5 minute timer will restart. If the guest then touches another source button, the TV will change to the selected source and the corresponding LED will be lit.

After an RJP Reset or a TV Power OFF/ON, it takes approx. 10 seconds to establish communications between the TV and the RJP.

English - 123