Dell PP29L owner manual Internal Card With Bluetooth Wireless Technology, Replacing Mini-Card

Replacing Mini-Card

NOTICE: The connectors are keyed to ensure correct insertion. If you feel resistance, check the connectors on the card and on the system board, and realign the card.

NOTICE: To avoid damage to the Mini-card, never place cables under the card.

1Insert the card connector into the system board connector at a 45-degree angle.

2Press the other end of the card down into the slot on the system board until the card clicks into place.

3Replace the securing screw.

4Connect the cables to the Mini-Card, ensuring that you route the cables correctly.

NOTE: For more specific information about which cable to connect to which connector, see the documentation that came with your Mini-Card.

5Secure unused antenna cables in the protective mylar sleeve.

6Replace the cover and tighten the eight captive screws.

Internal Card With Bluetooth® Wireless Technology

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.

NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as a connector on the back of the computer).

NOTICE: To help prevent damage to the system board, you must remove the battery from the battery bay before you begin working inside the computer.

If you ordered a card with Bluetooth wireless technology with your computer, it is already installed.

Removing the Card

1Follow the procedures in "Before You Begin" on page 107.

2Remove the hinge cover (see "Hinge Cover" on page 113).

3Remove the screw securing the card.

122

Adding and Replacing Parts