Samsung ML-2150 manual Configuring IPX Frame Types

7Press the Upper Level button ( ), then use the scroll button ().

8Press the scroll button ( or ) to display “DHCP” and press the Enter button ().

9To assign the address from the BOOTP server, press the Enter button () when “BOOTP” displays.

Configuring IPX Frame Types

On IPX/SPX protocol networks (for example, Novell NetWare), the format of network communication frames must be specified on the printer. In most cases, you can keep the default setting “AUTO”. However, you can manually set the frame type format, if required.

•AUTO (default): Automatically senses and limits the frame type to the first one detected.

•EN_8023: Limits the frame type to IPX over IEEE 802.3 frames. All others will be counted and discarded.

•EN_II: Limits the frame type to IPX over Ethernet Frames. All others will be counted and discarded.

•EN_8022: Limits the frame type to IPX over IEEE 802.2 with IEEE 802.3 frames. All others will be counted and discarded.

•EN_SNAP: Limits the frame type to IPX over SNAP with IEEE 802.3 frames. All others will be counted and discarded.

Note that the IPX/SPX protocol must be enabled in the Netware menu before you can configure frame types. See “Setting Network Protocols” on page E.7.

Take the following steps to change the frame type format:

1Press the Menu button () until you see “Network” on the bottom line of the display. Press the Enter button () to access the menu.

2Press the Enter button () when “Config Network” displays on the bottom line.

E.10 USING YOUR PRINTER ON A NETWORK