4.3 <

Network setup(ML-3471ND only)>
Configuring EtherTalk
EtherTalk is AppleTalk used in an Ethernet network. This protocol is
widely used in Macintosh network environments. To use EtherTalk, take
the following step:
1Press Menu until Network appears on the bottom line of the
display and press OK.
2Press the scroll buttons until EtherTalk appears and press OK.
3Press the scroll buttons until On appears and press OK.
4Press Stop to return to Standby mode.
Setting Ethernet speed
You can select the communication speed for Ethernet connections.
1Press Menu until Network appears on the bottom line of the
display and press OK.
2Press the scroll buttons until Ethernet Speed appears and press
OK.
3Press the scroll buttons until the speed you want appears and
press OK.
4Press Stop to return to Standby mode.
Restoring the network configuration
You can return the network configuration to its default settings.
1Press Menu until Network appears on the bottom line of the
display and press OK.
2Press the scroll buttons until Clear Setting appears and press OK.
3Press OK when Yes appears to restore the network configuration.
4Power the printer off and back on.
Printing a network configuration page
The network configuration page shows how the network interface card
on your printer is configured.
1Press Menu until Network appears on the bottom line of the
display and press OK.
2Press the scroll buttons until Network Info appears and press OK.
3Press OK when Yes appears.
The network configuration page prints out.