Samsung PS-50P2HT manual Remove four large screws from the rear side of the display

Installing the Display on the Wall Attachment Panel

ENG

4Remove four large screws from the rear side of the display.

Insert the bolts, dish-type washers, and insulation rubber into the four screw-holes as shown in the figure:

Bolt

Insulation rubber

5Put the insulation rubber point protruding from the rear top of the display in the groove on the top of the wall attachment panel. Lift up the display a little bit so that the insulation rubber point at the bottom of the rear side of the display is put to the groove at the bottom of the wall attachment panel. (Do not lift the display with any pressure. The insulation rubber at the top may be taken off.)

Œ

´

11