3.Push the connected cables into the inside of the Rod Coupling. At the same time, insert the Holder Housing into the Rod Coupling while fitting the Guide of the Holder Housing into the Guide Hole of the Rod Coupling. Then, turn the Holder Housing clockwise by approximately 18 degrees. Finally, secure the Holder Housing to the Rod Coupling using the 3 Screws (M4xL8, fitting).
-Install the Holder Housing so that the FRONT label faces the front of the camera to be installed.
-Make sure that the Bush Cable should not be loose from the Holder Housing. (If the Bush Cable is not secured firmly, the product is not properly waterproof.)
SCREW
| ROD COUPLING |
|
| GUIDE HOLE | ROD |
|
| |
BUSH CABLE |
| COUPLING |
|
| |
| GUIDE | HOLDER |
|
| |
| HOLDER | HOUSING |
|
| |
| HOUSING |
|
ROD COUPLING
HOLDER HOUSING
25
