Samsung SDC5440BC user manual Monitor, Setting the monitor, Setting Display position

monitor

You can configure information to be displayed.

Setting the monitor

Using the mouse may help make setup easier.

1.	Use the up/down buttons ($%) in <Device> window to
		Monitor
	move to <monitor>, and press [enTeR] button.
		Monitor	Spot Out	Mode
2.	Select <monitor>.
		 Event Display	OFF
		 Display	Date	Time	CH Name Icon
3.	Use direction buttons ($%_ +) to move to a desired	 Multi CH SEQ Time
			5sec
		 Video Output	VGA
	item, and set the value.
• Event Display : Sets the dwell time of the event channel
	display on the monitor when an event occurs.	Display Position Setup
	If selected <Continuous>, it displays the channel until you
			OK	Cancel
	press [aLaRm] button to release it.

•Display : Displays only checked items on the monitor screen.

•Multi CH SEQ Time : Sets the interval between automatic display switching in 4-split and 9-split mode of the Live screen.

•Video Out: You can set the video output mode.

-Auto : The default is set to Composite. (In VGA mode, the “SAMSUNG” logo will be displayed)

If a VGA source is connected, the source from the VGA will be displayed as main. (In Composite mode, the spot screen will be displayed)

The monitor distributor is not supported.

To switch to VGA mode, turn off the DVR set and connect the VGA jack. (The VGA monitor will turn on)

-VGA : The main video mode will switch to VGA after the DVR set reboots; the composite source will be displayed on the spot screen.

-Composite : The main video mode will switch to Composite after the DVR set reboots. (In VGA mode, the “SAMSUNG” logo will be displayed.)

4.When the monitor setup is done, press <OK>.

Setting Display position

Some monitors many not display information (camera name, icon, time information, etc.) about the DVR, depending on the condition. Then, you can change the display position of the data.

1.In the <Device> window, press the up/down ($%) button to move to <monitor> and press the [enTeR] button.

!main menu

2.Select the <monitor> item.

3.Select <Display Position Setup> in the bottom.

You will move to the <Display Position Setup> window.

4.Use the four direction buttons or the number buttons on the remote control to adjust the data position.

2012-01-01 01:10:25

Display Position Setup

30

30 30

30

OK Cancel

English _51