Samsung SDC5440BC user manual Setting the Protocol, Udp

• IP, Gateway, Subnet Mask, and DNS
		Connection Mode
- For <Static iP> : You can directly input IP address,
	Connection		Protocol
Gateway, Subnet Mask and DNS.
		 Connection Mode	ADSL
- For <Dynamic iP> : IP address, Gateway, and Subnet		 Bandwidth
			600kbps
		 IP	192.168. 1. 200
Mask are set automatically.		 Gateway
			192.168.1.1
- For <aDSL> : IP address, Gateway, and Subnet Mask are		 Subnet Mask
			255.255.255.0
		 DNS
			Manual	168.126.63.1
set automatically.
		 User ID	ID
• User ID, Password : In case you selected ADSL, provide the		 Password
			************
“user iD” and its “Password”.			OK	Cancel

M ` DNS server for <Dynamic IP> and <ADSL> can be set by user only if you selected <Manual>.

6.When the connection setup is done, press <OK>.

Setting the Protocol

1. Use the up/down buttons ($%) in <network> window to
		Connection Mode
	move to <Connection mode>, and press [enTeR]
		Connection	Protocol
	button.
		 Protocol Type	TCP
2.	Select <Protocol>.	 Port(UDP)
				8000 ~	8160
		 Port(TCP)	4520		~		4524
3.		 Unicast/Multicast
	Use direction buttons ($%_ +) to move to a desired		Unicast
		 TTL				5
	item, and set the value.	 Multicast IP	224.126.63.1
		 Webviewer Port
			80
• Protocol Type : Select the protocol type between TCP and
		TCP Port 4505~4530, Webviewer Port 80
		* Multi Browser Support :
	UDP.
	` If selected UDP, selections of Port (TCP), Port (UDP), and Unicast/		OK				Cancel
	Multicast are activated.
• Port (TCP) : Initially, <4520~4524> is set. It increases / decreases by 5.

- TCP : It has better stability and lower speed when compared to UDP, and recommended for internet environments.

• Port (UDP) : Initially, <8000~8160> is set. It increases / decreases by 160.

- UDP : It has less stability and faster speed when compared to TCP, and recommended for local area network (LAN) environments.

• Unicast/Multicast : Select one between Unicast and Multicast. If selected Multicast, Multicast IP and TTL are activated.

- Unicast : Transfers data (UDP, TCP) individually to each connecting client.

- Multicast : Multiple client can receive the data (only in UDP) without putting additional traffic load to the network.

• Multicast IP : User can directly input.

• TTL : Select from 0 ~ 255. Initial value for the TTL is set to <5>.

• Webviewer Port : Enter the port number for the Web Viewer. Initially, it is set to <80>.

• Multi Browser Support : You can use a Silverlight-compliant web browser to connect to the Web Viewer.
Multi browsers are enabled only if the TCP port is set to between 4505 and 4530 with the Web Viewer port
of 80. This is a security measure in order to enable Silverlight.
M	` As UDP protocol may cause a packet loss on the network, it is recommended to use TCP protocols.
	` If you select UDP protocols and set port forwarding in the IP router, ending up with an unstable network connection,
	configure the DMZ settings in the IP router as necessary.

4. When the protocol setup is done, press <OK>.

!main menu

English _61