3Motion Recording
Start recording when a motion is detected in the channel and area set by the Alarm/Motion Record Setup menu. When the motion record begins, the M mark is displayed next to the channel, indicating recording is on.
Note
- To enable the motion detection, you have to set an area for each channel. MOTION DETEC- TION operates only if there is a motion detected in the area of the channel you have selected.
4Alarm Recording
The Alarm In connector is located in the external in/out port of on the back panel of the system. You can connect the connector with an external device.
Then, set the EVENT RECORD ENABLE ‘On’ in the EVENT RECORD SETUP menu to start recording when an alarm occurs. When recording starts, the following screen appears.
Caution
Recording stops when the connection with input video signals is interrupted during recording. The system starts recording again when connection to input signals is restored. The system does not start recording when video signals are not connected to the Video In end.
