Samsung SIR-TS360 Setting your TV input button, Connecting the RF remote cable with RF receiver

3	CHAPTER 3
	Setting up and connecting
9	If you connected your TV using RGB/DVI or YPBPR output, press the output mode button to
	select RGB/DVI or YPBPR output mode.

(Optional) follow the instructions on the next page if you have a VCR and

10 want to hook up the VCR control.

11 Plug in the power cords for your TV, A/V receiver, and DIRECTV® HD Receiver.

Setting your TV input button

To view any of the programming from your DIRECTV® HD Receiver (satellite, cable, or off-air), set your TV to display the input from the video input jack you used to connect the DIRECTV® HD Receiver. (This is a setting on your TV usually controlled by a Video, Input, or Mode button. See your TV manual for help.)

Also, if necessary, set your A/V receiver to play the audio from the audio input jack you used to make the audio connection. See your A/V receiver manual for help.

Connecting the RF remote cable with RF receiver.

You can operate the Digital Satellite Receiver when installed in a cabinet or from another room in your house using the RF remote control. (Optional)

1Connect the RF Receiver to the RF REMOTE jack of the Digital Satellite Receiver.

NOTE

The operating range of the remote control is about 100 feet when connecting the RF receiver.

This may decrease due to ambient reception conditions, weak batteries, obstacle, etc...

35