Functional Description
OUT1 OFF/OUT2 OFF : If you want to cancel the operating Alarm outputs at once, select the corresponding menu to cancel the operating Alarm.
MD Dwell Time : When the Motion Detection function is on, the motion of intruders can be detected. When the motion is detected, the Alarm signal is displayed in the Alarm Output Terminal. For detailed settings of the Motion Detection for each Preset menu, see page 43 and 44.
Alarm Setting |
| Alarm Setting |
|
|
Alarm Enable | ON | Alarm Enable | ON |
|
Alarm Input |
| Alarm Input |
|
|
Alarm Output |
| Alarm Output |
|
|
MD Dwell Time | OFF | MD Dwell Time | ON | 30 SEC |
ON/OFF : It can be set up how long the operation will be kept when the motion is detected.
6) Initialization Setting
• Initialization Menu
Main Menu | Initialize |
Camera Setting | Power ON Reset |
Sequence Setting | Factory Default Set |
P/T Setting | Camera Default Set |
OSD Setting | Auto Refresh OFF |
Alarm Setting | Initial Position |
Initialize |
|
Status |
|
Power On Reset : Camera is initialized into the original status of power input. Factory Default Settings : Camera is initialized into the factory default settings.
Data including Preset is deleted. This function is used for initialization all settings.
Camera Default Settings: If only the camera module is replaced due to camera module failure, the new camera module can be set up with the settings of the old camera module.
Auto Refresh : The electric circuit and the status of the equipment parts within the camera are optimized regularly. (The cycle can be set up.) If camera faces toward a certain source of light or if the settings cannot be kept because of the long time rotation filming of a certain area, the Auto Refresh function is used to maintain and
OFF,
Initial Position : If you want to set the default direction of the camera so that the camera faces that direction when the power is turned on, you can set up the desired Pan and Tilt for the camera.
7) Status
The status of dome camera setting is displayed.
Main Menu | Camera Status | |
Camera Setting | CAM MODEL | = 30NC |
Sequence Setting | CAM VERSION | = 03.06 |
P/T Setting | DOME VERSION | = 00.18 |
OSD Setting | CON PROTOCOL | = SAMSUNG TW |
Alarm Setting | DOME ID | = 001 |
Initialize | CONTROLLER | = |
Status |
|
|
Cam Model = 30NC | Camera Model |
|
Cam Version = 03.06 | Camera S/W Version |
|
Dome Version = 00.01 | Control Board S/W Version | |
Dome ID=001 | Dome Camera ID |
|
Communication Mode Setup |
ENGLISH
SPEED DOME CAMERA 56 User’s Manual | SPEED DOME CAMERA 57 User’s Manual |