Samsung 3.5" hard disk drives, spinpoint v40 manual Table of Contents

TABLE OF CONTENTS

CHAPTER 1 SCOPE		1
1.1	USER DEFINITION	1
1.2	MANUAL ORGANIZATION	1
1.3	TERMINOLOGY AND CONVENTIONS	2
1.4	REFERENCE	3

CHAPTER 2 DESCRIPTION		4
2.1	INTRODUCTION	4
2.2	KEY FEATURES	4
2.3	STANDARDS AND REGULATIONS	5
2.4	HARDWARE REQUIREMENTS	5

CHAPTER 3 SPECIFICATIONS		6
3.1	SPECIFICATION SUMMARY	6
3.2	PHYSICAL SPECIFICATIONS	7
3.3	LOGICAL CONFIGURATIONS	7
3.4	PERFORMANCE SPECIFICATIONS	8
3.5	POWER REQUIREMENTS	9
3.6	ENVIRONMENTAL SPECIFICATIONS	10
3.7	RELIABILITY SPECIFICATIONS	11

CHAPTER 4 INSTALLATION		12
4.1	SPACE REQUIREMENTS	12
4.2	UNPACKING INSTRUCTIONS	13
4.3	MOUNTING	13
4.3.1	Orientation	13
4.3.2	Clearance	15
4.3.3	Ventilation	16
4.4	CABLE CONNECTORS	16
4.4.1	DC Power Connector	16
4.4.2	AT-Bus Interface Connector	16
4.5	JUMPER BLOCK CONFIGURATIONS	18
4.6	DRIVE INSTALLATION	20
4.7	SYSTEM STARTUP PROCEDURE	21
4.7.1	Drive Installation to Access the Full Capacity Using 32GB Clip	22

CHAPTER 5 DISK DRIVE OPERATION			23
5.1	HEAD / DISK ASSEMBLY (HDA)		23
5.1.1		Base Casting Assembly	23
5.1.2		DC Spindle Motor Assembly	23
5.1.3		Disk Stack Assembly	25
5.1.4		Head Stack Assembly	25
5.1.5		Voice Coil Motor and Actuator Latch Assemblies	25
5.1.6		Air Filtration System	25
5.2	DRIVE ELECTRONICS		26
5.2.1		Digital Signal Process and Interface Controller	26
5.2.2		AT Disk Controller	26
5.2.2.1 The Host Interface Control Block			28
5.2.2.2 The Buffer Control Block			29
5.2.2.3 The Disk Control Block			29
5.2.2.4 The Disk ECC Control Block			31
5.2.2.5		Frequency Synthesizer	31
5.2.2.6		Power Management	31
5.2.3		Read/Write IC	31
SpinPoint V40 Product Manual			iii