Samsung spinpoint v40 manual Drive Electronics, Digital Signal Process and Interface Controller

DISK DRIVE OPERATION

5.2 Drive Electronics

SpinPoint V40 drives attain their intelligence and performance through the specialized electronic components mounted on the PCBA. The components are mounted on one side of the PCBA.

The Preamplifier IC is the only electrical component that is not on the PCBA. It is mounted on the flexible circuit inside the HDA. Locating the Preamplifier IC as close as possible to the read/write heads via surface mount technology improves the signal to noise ratio.

5.2.1Digital Signal Process and Interface Controller

The DSP core controller incorporates a true 16-bit digital signal processor (DSP), a bus controller unit(BCU), an interrupt controller unit(ICU), a general purpose timer(GPT), and a 8K word SRAM.

5.2.2 AT Disk Controller

The AT disk controller works in conjunction with the DSP core to perform the ATA interface control, buffer data flow management, disk format/read/write control, and error correction functions of an embedded disk drive controller. The DSP communicates with the disk controller module by reading from and writing to its various internal registers.

To the DSP core, the registers of the disk controller appear as unique memory or I/O locations that are randomly accessed and operated upon. By reading from and writing to the registers, the DSP core initiates operations and examines the status of the different functional blocks. Once an operation is started, successful completion or an error condition may cause the disk controller to interrupt the DSP core, which then examines the status registers of the disk controller and determines an appropriate course of action. The local DSP core may also poll the device to ascertain successful completion or error conditions.

Figure 5-2illustrates the relationships between the various blocks within the AT disk controller. These blocks will be referred to throughout this document.

26 SpinPoint V40 Product Manual