![](/images/new-backgrounds/1200568/20056839x1.webp)
SERIES RECORDING, ALARM CONNECTIONS
Connecting for series recording
MAINTENANCE
If the picture is not clear on the screen, use the cleaning tape.
If the cleaning tape is playbacked for a long time, it may be harmful for the head.
IN OUTIN OUTIN OUT
VIDEO | VIDEO | VIDEO |
(TV or MONITOR)
1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | 10 | 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | 10 | 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | 10 |
7 SERIES OUT 8 GND | 9 SERIES IN |
|
• Select the SERIES REC ON in the | menu. | • Connect the second series output to the |
(Refer to page 17, REC MODE SETUP) | next series input, and connect the | |
• Connect the first series output to the | second series grounding to the next | |
second series input, and connect the first | series grounding. | |
series grounding to the second series |
| |
grounding. |
|
|
Connecting for alarm recording
1 Drop six to seven drops of head cleaning solution on the cleaning tape.
LIQUID
CLEANING
CLEANING | TAPE |
|
2 Insert the cleaning tape into your video and press the PLAY button.
REW
| PE |
ING | TA |
AN |
|
CLE |
|
3 After about 15 seconds, press the STOP button to stop the operation.
•Use the cleaning tape one more time when there is no normal picture.
STOP/EJECT
Rear of | (Outside unit) | ||||||||||||
1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | 10 | 1 | 2 | 3 | 4 |
|
|
|
|
1 | ALARM IN | 2 | ALARM OUT | 1 | GND | 2 | ALARM RESET |
3 | ALARM RESET | 8 | GND | 3 | ALARM IN | 4 | ALARM OUT |
(CAUTION) In the case of an outside unit, use connections that are appropriate for the alarm sensor in use.
•In the case of an outside unit, it is not necessary to make any connection if there is not any alarm reset output and alarm input.
Change the head under the following conditions
•The picture is not clear on the screen as the head is worn due to use of the video for an extended period of time.
•The head can be worn when using damaged or defective tapes or using the cleaning tape several times.
•The service life of the head varies depending upon the environmental conditions for use (temperature, humidity, dust, etc.). Replace the head when using your unit for more than 3,000 hours.
When the screen does not show a good picture
1.First press the TRACKING button.
2.Check to see whether the video output is properly connected.
3.Insert the cleaning tape. When the screen image is not improved even after repeating the above procedures, contact your dealer or service center.
MAINTEN- ANCE
37 | 38 |