ENGLISH
Basic Recording
Setting the Zero Memory (VP-D453(i)/D454(i)/D455(i) only)
✤The Zero Memory function works in both Camera and Player modes.
✤You can mark a point on a tape that you want to return to following playback.
1. Set the Power switch to CAMERA or PLAYER.
2. Set the Mode switch to TAPE.
1
3. Press the ZERO MEMORY button on the remote control before the recording or during playback at the point where you wish to return.
■ The time code is changed to a tape counter that is set to Zero Memory with the 
0:00:00 (Zero Memory indicator).
■If you want to cancel the Zero Memory function, press the ZERO MEMORY button again.
4. Finding the zero position. |
| |
■ | When you have finished playback, fast forward or rewind the tape in stop mode. | œ |
| The tape stops automatically when it reaches the zero position. | |
■ | When you have finished recording, set the Power switch to PLAYER and press the |
|
| (REW) button. |
|
| The tape stops automatically when it reaches the zero position. |
|
5.The tape counter with the 
(Zero Memory indicator) disappears from the display and the tape counter is changed to the time code.
[ Notes ]
■In the following situations, Zero Memory mode may be canceled automatically:
-At the end of the section marked with the Zero Memory function.
-When the tape is ejected.
-When you remove the Battery pack or power supply.
■The Zero Memory may not function correctly where there is a break between recordings on the tape.
42
