CAUTION
•Use the FLAP button on the remote control to adjust the position of the flap. If you move the flap by hand, the flap position according to the remote control and the actual flap position may no longer match. If this should happen, shut off the unit, wait for the flap to close, and then turn on the unit again; the flap position will now be normal again.
•Do not have the flap pointed down during cooling operation. Condensation may begin to form around the air vent and drip down.
CAUTION
1.Never use solvents, or harsh chemicals when cleaning the indoor unit. Do not wipe the plastic casing using very hot water.
2.Some metal edges and the fins are sharp and may cause injury if handled improperly; be especially careful when you clean these parts.
3.The internal coil and other components of the outdoor unit must be cleaned every year. Consult your dealer or service center.
OPERATION WITHOUT THE REMOTE CONTROL UNIT 
INDOOR UNIT
OPERATION lamp
OPERATION button (ON/OFF)
If you have lost the remote control unit or it has trouble, follow the steps below.
When the air conditioner is not running
Each time the OPERATION button is pressed, the operation mode changes cyclically.
Cooling operation |
| Stop |
|
NOTE
The temperature is set to the room temperature minus 4°F during the cooling operation, and the fan speed and flap are set to Auto.
CARE AND CLEANING 
1.For safety, be sure to turn the air
conditioner off and also to disconnect the power before cleaning.
2.Do not pour water on the indoor unit to clean it. This will damage the internal components and cause an electric shock hazard.
Casing and Grille (Indoor Unit)
Clean the casing and grille of the indoor unit with a vacuum cleaner brush, or wipe them with a clean, soft cloth.
If these parts are stained, use a clean cloth moistened with a mild liquid detergent. When cleaning the grille, be careful not to force the vanes out of place.
Anti-Mold Filter
The
How to remove the anti-mold filter
1.Grasp both ends of the front panel and pull forward and up to open the front panel.
Front panel
| Protrusions |
2.Lift the
3.Pull downward to remove the filter from the unit.
Cleaning
Use a vacuum cleaner to remove light dust. If there is sticky dust on the filter, wash the filter in lukewarm, soapy water, rinse it in clean water, and dry it.
How to replace the anti-mold filter
1.Insert the top of the
2.Close the front panel by pushing the center of the front panel and then pressing both edges until the panel clicks into place.
2 1 2
Air Clean Filter
The air clean filter removes dust and dirt from the air, and reduces odors and smoke from tobacco.
15 | |
|
