UP016DH(CLT5812) ENG OM 3/7/05 5:21 PM Page 5

GETTING STARTED

B. Install the rechargeable battery packs into the handsets

Both handsets are powered by a rechargeable battery packs.

The battery recharges automatically when the handset is placed in the base unit or charging cradle.

IMPORTANT

Use only the Sanyo rechargeable battery pack supplied with your cordless telephone.

Charge the handset battery packs for at least 15-20 hours before

using your new cordless telephone for the first time! To maximize the charge capacity of your battery pack, DO NOT plug the telephone cord into the base unit and wall jack until the battery is fully charged.

1 Press down on the handset battery case cover (use the finger indention for a better grip) and slide the cover downward to remove.

2 Plug the battery pack connector (red & black wires) into the small, black jack inside the battery compartment.

(The connector notches fit into the grooves of the jack only one-way.) Match the wire colors to the polarity label in the battery compartment, connect the battery and listen for a click to ensure connection.

3 Make sure you have a good connection by pulling slightly on the battery wires. If the connection is secure, the battery jack will remain in place.

4 Place the battery case cover back on the handset by sliding it upwards until it clicks into place.

Note:

Red

 

 

Black

Red

Black

 

Wire

Wire

Place the second handset in the charger with the keypad facing forward for 15-20 hours before use.

E5

Page 7
Image 7
Sanyo CLT-5812 instruction manual Install the rechargeable battery packs into the handsets