Sanyo CLT-5812 instruction manual Editing a stored name and/or phone number, SELECT/CH key

UP016DH(CLT5812) ENG OM 3/7/05 5:22 PM Page 27

DIRECTORY

Editing a stored name and/or phone number

1	Press the MEM key in the standby mode,
	¨Select Memory¨ is displayed.
2	Press the	VOL/RING or	VOL/RING
	key, or enter a number (0 - 9) to select
	the memory location you would like to
	edit, and press the MEM or
	SELECT/CH key.
3	Press the MEM or SELECT/CH key again.

The following screen appears with the memory location number that you have selected in the display.

Select Memory

01SANYO

02Alison

01:SANYO

9057609944

Edit Memory01

Delete Memory01

Go Back

4 Press the	VOL/RING or	VOL/RING key to select ¨Edit MemoryXX¨,
then press the MEM or SELECT/CH key. The following screen appears.
The cursor flashes, indicating that the display is ready for the name
to be edited. When a name has not been			Store Name
stored, the cursor appears at the beginning			SANYO

of the second line.

5 Use the /TONE/ , #/ , DELETE/TRANS, or any number key to edit the name. (See page E23.) To edit only the phone number, skip this step.

6	Press the MEM or SELECT/CH key. The	Store Number
		9057609944
	following screen appears.

The cursor flashes indicating that the display is ready for the number to be edited.

7 Use the /TONE/ , #/ , REDIAL/PAUSE, DELETE/TRANS, or any number key to edit the phone number. The phone number cannot exceed 20 digits. (See page E22.)

If you don´t want to change the phone number, skip this step.

E27