Setting
Lamp control
Lamp control | Lamp life control |
|
This function allows you to change brightness of the screen.
Auto . . . . . Brightness according to the input signal.
Normal . . . Normal brightness.
Eco 1 . . . . Lower brightness and decrease of fan speed. Lower brightness reduces the lamp power consumption and extends the lamp life.
Eco 2 . . . . Lower brightness and increase of fan speed. Lower brightness reduces the lamp power consumption and extends the lamp life. It is recommended to use Eco 2 when using the projector continuously over a long period of time. The fan noise becomes louder in Eco 2 than in Eco 1. Select the suitable mode for the used environment.
PNote:
The fan noise becomes louder in Eco 2 than in Eco 1.
Select the suitable mode for the used environment.
Lamp life control
Select the lamp operation when the total lighting time of a lamp exceeds the recommended total hours of use.
Mode 1 ............ | A lamp can be turned on even after |
| exceeding the recommended total hours of |
| use. |
Mode ............ | A lamp can be turned on even after |
| exceeding the recommended total hours of |
| use. But the projector turns off automatically |
| after 3 minutes. |
PNote:
•Lamp mode cannot be changed for a while after turning on the projector. Lamp needs some time to stabilize after the power is turned on. Stored lamp mode will be active after the lamp is stabilized.
•If Mode 2 has been selected and the projection lamp exceeds the recommended total hours of use, the replacement icon will be displayed at the time of
Then the projector will turn off after 3 minutes.
Lamp replacement icon
The Lamp replacement icon will not appear when the Display function is set to Off (p.52), during "Freeze" (p.30) or "No show" (p.29).
55