Setting

RC sensor

Select a location of the infrared remote receiver of the remote control. See “Remote Control Receivers and Operating Range” on page 15 for details.

All............

Activate all of the receivers.

Front & Top . .

. . . .Activate both the front and top receivers.

Top & Back . .

. . . .Activate both the top and back receivers.

Front & Back

. . . .Activate both the front and back receivers.

Front .......

Activate only the front receiver.

Top..........

Activate only the top receiver

Back........

Activate only the back receiver.

Power management

For reducing power consumption as well as maintaining the lamp life, the Power management function turns off the projection lamp when the projector is not operated for a certain period.

Select one of the following options:

Ready ..................

When the lamp has been fully cooled down, the

 

POWER indicator changes to green blinking. In

 

this condition, the projection lamp will be turned

 

on if the input signal is reconnected or any

 

button on the side control or remote control is

 

pressed.

Shut down...........

When the lamp has been fully cooled down, the

 

power will be turned off.

Off ........................

Power management function is off.

Timer....................

If the input signal is interrupted and no button

 

is pressed for more than 30 seconds, the timer

 

display with No signal appears. It starts the

 

countdown until the lamp is turned off. Use the

 

Point PQ buttons to set the Timer(1~30Min).

PNote:

Factory default is Ready: 5 Min.

Standby mode

This function is available when operating the projector via network.

Network ..........

Supply the power to the network function

 

even after turning off the projector. You can turn

 

on/off the projector via network, modify network

 

environment, and receive an e-mail about projector

 

status while the projector is powered off.

Eco....................

Select Eco when you do not use the projector

 

via network. The projector’s network function will

 

stop when turning off the projector.

Refer to the owner’s manual of “Network Set-up and Operation”.

PNote:

•Factory default is Network.

•When selecting Network, the cooling fans may be running depending on the temperature inside the projector even if the projector is turned off.

Power management

Timer left before Lamp is off.

Min

Min

57