Sanyo PLC-XP200L owner manual Mouse Pointer button, Timer button, Freeze button, Filter button

Basic Operation

MOUSE POINTER button

Move the pointer on the screen with this button.

POINTER button

Press POINTER button on the remote control to display the Pointer on the screen.

P-TIMER button

Press the P-TIMER button on the remote control. The Timer display “00 : 00” appears on the screen and starts to count time (00 : 00–59 : 59).

To stop the P-TIMER, press the P-TIMER button.

To cancel the P-TIMER, press the P-TIMER button again.

P-Timer display

Remote Control

	MOUSE
	POINTER
	button
	POINTER button
	P-TIMER button
KEYSTONE	FREEZE button
button

FILTER button

FREEZE button

Press the FREEZE button on the remote control to freeze the picture on the screen. To cancel the FREEZE function, press the FREEZE button again or press any other button.

✔Note:

•See the previous page for the description of other buttons.

FILTER button

Press and hold the FILTER button for more than five seconds to operate electrically operated filter to replace the filter.

✔Note:

•The filter cannot be rewound.

•When the filter is replaced, the total accumulated time of the filter use is automatically set to 0.

KEYSTONE button

Press the KEYSTONE button on the remote control. The “Keystone” appears on the screen.

Use the Point ed7 8 buttons to correct keystone distortion. The keystone adjustment can be stored (pp.44, 48).

•The white arrows indicate that there is no correction.

•A red arrow indicates the direction of correction.

•An arrow disappears at the maximum correction.

•If you press the KEYSTONE button on the remote control again while the Keystone dialog box is being displayed, the keystone adjustment will be canceled.

•The adjustable range can be limited depending on the input signal.

•“Keystone” disappears after 10 seconds.

Reduce the upper width with	Reduce the lower width	Reduce the left part with
Point e button.	with Point d button.	Point 7 button.

Reduce the right part with Point 8 button.

33