Appendix
| – Power management function runs by initial setting. Check “SETTING” section on page | |
| 56. | |
| – When the filter cartridge replacement icon keeps appearing on the screen at turning | |
The power is turned off | on the projector for some time and no action is taken to replace the filter cartridge, the | |
projector will be automatically shut down in 3 minutes after turning on to protect the | ||
automatically. | ||
projector. (See pages | ||
| ||
| – Do not cover the ventilation slots on the projector. (See pages 4, 6) | |
| – Projector may be used in high ambient temperature environment. Make sure the | |
| temperature is not out of Operating Temperature | |
You cannot operate with | – The side control is not available. If the side control is locked at “Key lock” under | |
the side control. | “Security” of SETTING section. Please check “SETTING” section on page 57. | |
|
| |
| – Check the batteries. | |
| – Check if the RC sensor is set properly. (See page 56) | |
| – Make sure no obstruction is between the projector and remote control. | |
| – Make sure you are not too far from the projector when using the remote control. | |
| Maximum operating range is 16.4’ (5m). | |
The Remote Control does | – Make sure that the remote control code conforms to the projector’s code. (See | |
“SETTING” section on page 55.) | ||
not work. | ||
– Unlock the Key lock function for the remote control. (See page 57) | ||
| ||
| – Wireless remote control does not work when the remote control cable is connected to | |
| the projector. (See page 16) | |
| – Check if the | |
| – Make sure that the simple mode in the remote control function is set to “Off“ (See | |
| page 55). | |
Wireless mouse function | – Check the cable connection between the projector and your computer. (See page 34) | |
– Check the mouse setting on your computer. | ||
does not work. | ||
– Turn on the projector before you turn on the computer. | ||
| ||
|
| |
Indicators blink or light. | – Check the status of the projector with referring to “ INDICATORS AND PROJECTOR | |
CONDITION” on pages | ||
| ||
|
| |
| – Your operation is invalid. Operate correctly. | |
appears on the screen |
| |
|
| |
Unable to unlock the Logo |
| |
PIN code lock, Security | – Contact the dealer where you purchased the projector or the service center. | |
key lock or Security PIN | ||
| ||
code lock. |
| |
|
| |
Forget the Logo PIN code | – Contact the dealer where you purchased the projector or the service center. | |
or Security PIN code. | ||
|
WARNING:
High voltages are used to operate this projector.. Do not attempt to open the cabinet..
If problems still persist after following all operating instructions, contact the dealer where you purchased the projector or the service center. Specify the model number and explain about the problem. We will advise you how to obtain service.
71
