Part Names and Functions
Remote Control Battery Installation
1 | Open the battery | 2 | Install new batteries | 3 | Replace the |
| compartment lid. |
| into the compartment. |
| compartment lid. |
Press the lid downward and slide it.
Two AAA size batteries
For correct polarity (+ and
To insure safe operation, please observe the following precautions : ● Use two (2) AAA or LR03 type alkaline batteries.
●Always replace batteries in sets.
●Do not use a new battery with a used battery.
●Avoid contact with water or liquid.
●Do not expose the remote control to moisture or heat.
●Do not drop the remote control.
●If the battery has leaked on the remote control, carefully wipe the case clean and install new batteries.
●Risk of an explosion if battery is replaced by an incorrect type.
●Dispose of used batteries according to the instructions.
Remote Control Receiver and Operating Range
Point the remote control toward the projector (to an Infrared | 16.4’ |
Remote Receiver) when pressing the buttons. Maximum | (5 m) |
operating range for the remote control is about 16.4’ (5 m) | 60° |
and 60 degrees in front and rear of the projector. | |
Infrared Remote Receivers are provided both in front and |
|
back of the projector. You can conveniently use both of | 60° |
them (see pages 9, 14). |
|
Adjustable Feet
Projection angle can be adjusted up to 5.0 degrees with the adjustable feet.
Rotate the adjustable feet and tilt the projector to the proper height; to raise the feet, rotate the both feet clockwise.
To lower or to retract the adjustable feet, rotate the both feet counterclockwise.
To correct keystone distortion, press the KEYSTONE button on the remote control or select Keystone from the menu.
Adjustable Feet
18
