Setting
Power management
For reducing power consumption as well as maintaining the lamp life, the Power management function turns off the projection lamp when the projector is not used for a certain period.
If the input signal is interrupted and no button is pressed for more than 30 seconds, the timer display with “No signal” appears. It starts the coutdown until the lamp is turned off. The countdown time can be set between
Select one of the following options:
Ready | When the lamp has been fully cooled |
| down, the POWER indicator changes to |
| green blinking. In this condition, the |
| projection lamp can be turned on if the |
| input signal is reconnected or any button |
| on the top control or remote control is |
| pressed. |
Shut down | When the lamp has been fully cooled |
| down, the power will be turned off. |
Off | Power management function is off. |
On start
When this function is set to “On,” the projector will be automatically turned on just by connecting the AC power cord to a wall outlet.
✔Note:
•Be sure to turn off the projector properly (see “Turning Off the Projector” on page 22). If the projector is turned off in the incorrect sequence, the On start function does not work properly.
Power management
Time left before the lamp is off.
Press the SELECT button at Power management and this dialog box appears. Use the Point 78 buttons to choose one of the three options. Press the Point d button to select the timer, and then use the Point 78 buttons to set timer.
58
