Sanyo PLC-XT25 owner manual Remote control Display

Setting

Remote control

The eight different remote control codes (Code 1–Code 8) are assigned to the projector; the factory-set, initial code (Code 1) and the other seven codes (Code 2 to Code 8).

The same code should set on both the projector and the remote control. For example, operating the projector in “Code 7”, the remote control code also must be switched to “Code 7”.

To change the code for the projector

Select a remote control code in this Setting Menu.

To change the code for the remote control:

While holding down the MENU button, press the IMAGE button number of times corresponding to the remote control code for the projector. (See page 14 for details.)

RC sensor

Select a location of the infrared remote receiver of the remote control. See “Remote Control Operating Range” on page 24 for details.

Both	Activate both the front and back receiver.
Front	Activate only the front receiver.
Back	Activate only the back receiver.

Display

This function decides whether to display On-Screen Displays.

On	Show all the On-Screen displays. Use
	this function when you want to
	project images after the lamp
	becomes bright enough. The factory
	default setting is in this option.
Countdown Off	Show the input image instead of the
	countdown when turning on the
	projector. Use this function when you
	want to project the image as early as
	possible even when the lamp is not
	bright enough.
Off	Hide the On-Screen Displays except;
	●On-Screen Menu
	●“Power off?”
	●“No signal” for Power management
	(p.39)
	●“Please wait ...”
	●White arrows for the True function
	in the Screen Menu. (p.37)

Remote control

Display

Use the Point 78 buttons to swith between the options.

57