Turn off the projector and unplug the AC power cord. Allow the projector to cool for at least 45 minutes.
Turn the projector over. Loosen the screw that secures the lamp cover, and then open the lamp cover.
Loosen the two (2) screws that secure the lamp. Lift the lamp out of the projector by using the built in handle.

Maintenance and Cleaning

Lamp Replacement

When the life of the projection lamp of this projector draws to an

end, the LAMP REPLACE indicator emits a yellow light. If thisTop Control indicator lights yellow, replace the lamp with a new one promptly.

The time when the LAMP REPLACE indicator should light is depending on the lamp mode.

This indicator lights yellow when the life of the projection lamp draws to an end.

CAUTION

Allow the projector to cool, for at least 45 minutes before you open the lamp cover. The inside of the projector can become very hot.

CAUTION

For continued safety, replace the lamp with the same type. Do not drop the lamp or touch the glass bulb! The glass can shatter and may cause injury.

Screw

Lamp Cover

Follow these steps to replace the lamp.

1

2

3

4

Replace the lamp with a new one and secure it with the two

 

 

 

(2) screws. Make sure that the lamp is set properly. Replace

Lamp

Handle

 

the lamp cover and secure it with the screw.

 

 

5

Connect the AC power cord to the projector and turn on the

 

 

 

projector.

 

 

6

Reset the Lamp replacement counter.

 

 

 

See “Lamp Replacement Counter” on the next page.

 

Screws

ORDER REPLACEMENT LAMP

Replacement lamp can be ordered through your dealer. When ordering a projection lamp, give the following information to the dealer.

●

Model No. of your projector

:

PLV-Z4

●

Replacement Lamp Type No.

:

POA-LMP94

 

 

 

(Service Parts No. 610 323 5998)

46