Connection of LAN cable

[2] Connection of LAN cable

To connect to the network, it is required to use the UTP (Unshielded Twisted Pair) strait cable with RJ-45 plug. There are two different types of cables depending on whether the network is constructed with 10Base-T or 100Base-TX. Prepare the Hub (10Base-T or 100Base-TX) to distribute the network cable if required.

1 Disconnect the AC plug from the projec- tor.

2 Connect the UTP strait cable to the LAN port on the network board.

3 Connect the UTP strait cable to the hub.

Hub

(10BaseT, 100Base-TX)

Projector

UTP strait cable

ENGLISH

✐Use the UTP cross cable when you connect the computer and projector directly not using the hub.

✐When you connect the projector into the 10Base-T network, use cable with category 3 or 5. When you connect the projector into the 100Base-TX network, use cable with category 5.

✐The length of cable between hub and projector should be less than 100m.

PJ-Net Organizer 13

OWNER’S MANUAL