Network configuration

How to enter the numbers

To move the selection and change the values, Use the pointers ▲/▼/▲ projector or on the remote control handset.

The ▲ / ▲ keys are used to move the selection item. The ▲/ ▼ keys are used to change the number value.

/ ▲ on the

3 Restart the Network board

Press the SELECT button again. The network configuration display disappears and the network board begins restarting*1. It takes about 60 seconds. Do not disconnect the AC cord from the projector.

Completing of installation

Now the installation is completed. The IP address of this projector was set to “192.200.1.201”. Next, please see chapter “Basic setting and operation” on page 25. It describes basic setup and operation of the projector.

Password setting menu [Display]

A password can be set to restrict access to the setting pages of the projector using the web browser. The default password is set “0000” as no password.

Use the projector’s menu and select the Display icon on the Setting sub menu, and then press the SELECT button on the projector twice. The following setting display appears on the screen. The numbers on the display indicates the current password. To change the password, enter your desired number by using the pointers on the projector or remote control handset, and then press the SELECT button. The password setting display disappears and the network board begins restarting*1. It takes about 60 seconds. Do not disconnect the AC cord from the projector.

Password2.a1.w52751nSm3[(ass) sTd (word 2 -f20.023 223.97 141.678 -25.3 4C

ENGLISH

PJ-Net Organizer 17

OWNER’S MANUAL