Sanyo POA-PN01 Configure the network with the computer

Installation

B	Configure the network with the computer
	This example explains how to set the following configuration.
	IP Address	: 192.200.1.201
	Subnet Mask	: 255.255.255.0
	Default Gateway : 192.200.1.1
	DNS	: 0.0.0.0

The default network configuration is set as follows.

IP Address	: 192.168.0.2
Subnet Mask	: 255.255.255.0
Default Gateway	: 0.0.0.0
DNS	: 0.0.0.0

Make sure that the projector is connected to the network and then connect the AC cord to the outlet.

1 Temporarily*1 set up your computer network configuration to the same IP network

number as the PJ-Net Organizer. For example, change your computer network configuration as follows and restart the computer.

IP Address	: 192.168.0.2
Subnet Mask	: 255.255.255.0
Default Gateway	: (blank)
DNS	: (blank)

The network configuration of computer differs depending on each network environment or your computer. For further information, please see the next chapter “Configure the network of computer”.

*1 Change your computer’s network configuration temporarily. After completing the set up for the projector, you must set up again to the original network configuration for your computer. It is recommended to make a note of those network settings.

18