Basic Setting and Operation

Examples: Type and contents of alert mail

When the projector has an abnormality, the following alert messages are sent to the registered E-mail address according to your selected condition. Administrator or user can take an efficient action quickly by receiving this massage. This is very useful to maintain and service the projector.

The following are examples of received messages.

●When the internal temperature is too high:

TITLE: Message from projector 01-01-2001 00:59

Projector Model Name: XP41/XP46

TCP/IP: 192.168.0.2 Projector Name: myProjector

It sends you following massage.

*The Projector lamp is turned off, because internal projector temperature is too high.

Wait Temperature Warning Indicator turned off,turn the Projector on again. If the Indicator continues to flash,check the air filter for dust accumulation.

[A]36.5 Degree [B] 46.5 Degree [C] 58.2 Degree Temperature of Sensor C is too high.

✐The PJ-Net Organizer let users know the information which thermal sensor [A], [B] or [C] inside the projector detected the abnormal temperature risen and so the projector was turned off. Please refer to page 35 for the location of the sensors [A], [B] and [C], and temperature. Also see the owner's manual of the projector for further details.

●When the internal power circuit is failed:

TITLE: Message from projector 01-01-2001 00:58

Projector Model Name: XP41/XP46

TCP/IP: 192.168.0.2 Projector Name: myProjector

It sends you following massage.

*The Projector lamp was turned off, because projector power circuit failed. Unplug the projector from AC outlet and ask servicing to qualified service personnel.

✐The Projector lamp was turned off, because the projector power circuit failed.

Unplug the projector from AC outlet and ask servicing to a qualified service personnel.

●When the life span of lamp is reached:

TITLE: Message from projector 01-01-2001 00:58

Projector Model Name: XP41/XP46

TCP/IP: 192.068.0.2 Projector Name: myProjector

It sends you following massage.

*The life span of lamp is reached.

✐Replace it with a new lamp immediately and reset the lamp counter. If the projector is used without reset the lamp counter, the alert mail is sent to users in every power- on of the projector. This alert mail will not be sent when unchecking the mail sending condition "When the life span of lamp is reached".

32