Sanyo POA-PN10 owner manual Examples Type and contents of alert mail, English

E-Mail setting

4 Condition selection for sending alert message

Check the condition items under which alert messages will be sent and press the Set button.

Please refer to chapter “Examples :Type and con- tents of alert messages” described on next page.

Note:

A free message can be sent when the lamp use time reaches the preselected lamp use time.

Check the “lamp use time” and enter a setting time. Input a free message on the attached message text box and then press the Set button.

The length of message should be less than 256 characters.

Examples: Type and contents of alert mail

When the projector has an abnormality, the following alert messages are sent to the registered E-mail address according to your selected condition. Administrator or user can take an efficient action quickly by receiving this massage. This is very useful to maintain and service the projector.

The following are examples of received messages.

●When the internal temperature is too high:

TITLE: Message from projector 01-01-2003 00:59

Projector Model Name: XT10A/XT15A

TCP/IP: 192.168.0.2 Projector Name: myProjector

It sends you following massage.

*The Projector lamp is turned off, because internal projector temperature is too high.

Wait Temperature Warning Indicator turned off,turn the Projector on again. If the Indicator continues to flash,check the air filter for dust accumulation.

[A]36.5 Degree [B] 46.5 Degree [C] 58.2 Degree Temperature of Sensor C is too high.

✐The Network Unit let users know the information which thermal sensor [A], [B] or [C] inside the projector detected the abnormal temperature risen and so the projector was turned off. Please refer to page 37 for the location of the sensors [A], [B] and [C], and temperature. Also see the owner's manual of the projector for further details.

Network Unit

OWNER’S MANUAL

ENGLISH

33