Installation
[1] Mounting
1 Disconnect the AC plug from the projector.
2 Remove all of the hole covers (3 round type, 4 square type) on the rear of the projector and insert plug on this product to the DVI connector.
Mount as the SW lever on the Unit presses the mount detect- ing SW on the projector.
3 Tighten three screws by using a | Mount detecting SW |
coin etc. | hole covers |
Note:
This network unit is connected to the DVI ter- minal on the projector, therefore, the digital input does not be used when this unit is mounted. The analog input of the Computer 2 can be used through the VGA terminal on the network unit.
*Please use a VGA cable supplied with your projector.
VGA cable
From computer
!Caution
✐The AC cord must be disconnected from AC power outlet when mounting or removing this product. It may damage the product.
✐Do not connect the AC cord until after connecting the LAN cable and computer.
12