Sanyo POA-PN10 owner manual Setting items and their operations are listed below

Controlling the Projector

The setting items and their operations are listed below.

Setting items	Operation
Language	Select the language used in the on-screen menu of the projector. Select your
	desired language with the pull down menu button, and then press the Set button.
Keystone	Correct the distortion of the projected image with the Left, Right, Up and
	Down buttons. To cancel the keystone correction, press the OFF button.
Blue back	When this setting is ON, the projector displays a blue image when no input
	signal is selected.
Display	This setting is to select whether to display the on-screen display menu.
Logo	When this setting is ON, the projector displays a logo when starting up.
Ceiling	When this setting is ON, the picture is reversed top/bottom and left/right.
Rear	When this setting is ON the picture is reversed left/right.
No Show	When this setting is ON the picture on the screen is black out.
Freeze	When this setting is ON, the picture on the screen is frozen.
Power Management	When this setting is ON, the projector will automatically turn the lamp off if the
	input signal is interrupted and no control button is pressed for 5 minutes and
	30 seconds. Set OFF to disable this function.
On Start	When this setting is ON, the projector is automatically turned on just by con-
	necting the AC power cord to a wall outlet.
Timer Setting	Turns the projector on or off at a preselected day/date and time. Please see
	chapter [Timer Setting] on the next page for more information.
Remote Control	8 different remote control codes can be set. Must be set the same code num-
	ber with the remote control when this code is changed.
Lamp Counter Reset	This is used to reset the lamp-use time. When replacing the lamp, reset the
	lamp-use time by pressing the Yes button. Another popup window*1 will
	appear for confirmation and then press the Yes button to reset.
Lamp Mode*	This is used to switch the lamp mode. When Eco is selected, the projector
	reduces the brightness and sets into the low power consumption mode.
	* Some projectors may not have this menu.
P-TIMER	When P-TIMERbutton is pressed, the timer display "00:00" appears on the
	screen and timer starts to count the time (00:00 ~ 59:59). To stop the time
	counting, press P-TIMERbutton and press this button again to cancel the P-
	TIMER function. The status is changed as ON -> STOP -> OFF when this but-
	ton is pressed repeatedly.

[Note]

*1 This popup window is realized by using the JavaScript function of web browser. If the prefer- ence of the browser is set not to use the JavaScript, the lamp counter is reset immediately without displaying the popup window for confirmation. To display the confirmation window, please change your preference to use the JavaScript function.

There are various kind of ways to change this preference depending on the web browser's version and application. Please refer to chapter “Appendix: Web browser setting/Active Script (JavaScript enable)” on page 68.

44