TANDBERG 6000MXP user manual IP Settings

Administrator Settings

4.8.2.1 IP Settings

Remember to“restart the system” after making changes to IP Settings. This can be done by selecting the Save and Restart at the bottom of the IP setting menu. Changes in IP Settings menu will not have any effect before the system is restarted.

IP-assignment

DHCP (Dynamic Host Configuration Protocol) can be selected when a DHCP server is present.

DHCP IP-address, IP-subnet mask and Gateway are not used because the DHCP server assigns these parameters.

Static The system’s IP-address, IP-subnet mask and Gateway must be specified in the IP- address field.

IP-address

IP-address defines the network address of the codec. This address is only used in static mode. In DHCP-mode, the assigned IP-address can be found on the Welcome Menu.

IP-subnet mask

IP-subnet mask defines the type of network. This address is only used in static mode. Your LAN- administrator will provide the correct value for this field.

Gateway

When using DHCP, the default gateway will be set automatically. If the LAN utilizes static IP addresses, IP address, subnet mask, and default gateway must be specified by the LAN administrator.

Ethernet Speed

Auto	The codec will auto-detect the speed/duplex on the LAN.
10/Half	The codec will connect to the LAN using 10Mbps speed/Half Duplex.
10/Full	10 Mbps speed/Full Duplex.
100/Half	100	Mbps speed/Half Duplex.
100/Full	100	Mbps speed/Full Duplex.

201