TANDBERG 6000MXP user manual Monitors, Codec, Column and Base, Remote Control

Introduction

Monitors

The main monitor displays the far-end and near-end videoconferencing sites in addition to the menus and video from connected video sources.

Note that the TANDBERG 6000 MXP Profile is shipped with different” monitors depending” on product” variants; there are two ”different variants of the system: 43 , which has a 43 monitor and the 50 variant, which has a 50 monitor. Hence, the pictures/drawings used in this manual might differ from the actual monitor model shipped with the system.

Codec

The codec is the heart of the system. Its main task is the compression of outgoing video, audio and data, the transmission of this information to the far end, and the decompression of the incoming information. The name codec comes from a combination of the two words compression and decompression.

Column and Base

The Roll About system is easily movable due to large wheels and handles, at the back of the monitor. The codec is located inside the bracket assembly behind the monitor. Inside the column assembly, there is room for additional equipment, e.g. a VCR or a DVD player.

Remote Control

The remote control is used to control all functions of the system. If the screen saver is activated (black monitor), touching the remote control will automatically wake up the system. The remote control uses 4 AAA batteries. The system will tell you when batteries are running low. Change the batteries at the back of the remote control.

The reach of the remote control signal is 20 meters (65 ft). For users sitting in an open plan office, this can cause problems. Use the little, white switch placed in the batteries compartment to change the reach of the signal from 20 meters to 2 meters (6.5 ft). This will prevent you from unintentionally controlling another video system, when you control your own system.

15