Sanyo WTC500L owner manual Remote Control Code

Part Names and Functions

Remote Control Code

The eight different remote control codes (Code 1–Code 8) are assigned to this projector. Switching the remote control codes prevents interference from other remote controls when several projectors or video equipment next to each other are operated at the same time. Change the remote control code for the projector first before changing that for the remote control. See “Remote control” in the Setting Menu on page 55.

1	Press and hold the MENU and a number button (1–8)
	for more than five seconds to switch between the
	codes.
2	To initialize the remote control code, slide the RESET/
	ON/ALL-OFF switch to “RESET,” and then to “ON.” The

initial code is set to Code 1.

MENU button

Number buttons

RESET/ON/ALL OFF

Switch

Press and hold the MENU and a number button (1–8) that corresponds to the remote control code for more than five seconds to switch between the codes.

✔Notes:

•When using as a wired remote control while the standby mode is set to “Eco”, the same remote control code should be set on both the projector and the remote control to turn on the projector. (p.56)

17