Introducing the AllTouch Remote Control
Your new AllTouch® Remote Control can do the job of four separate remote controls. In fact, it can control four devices at one time. These can be any combination of:
• Home Terminals or 8600xTM Home Communications Terminals (HCTs)
• Televisions | • VCRs | • Home automation devices |
• Cable audio receivers | • CD players |
|
Setup
When you first receive your AllTouch Remote Control, you will have to tell it each brand of equipment you want it to control. We call this setup. The cable mode is already set up for home terminals/HCTs.
In the back of this guide, is a list of numbers starting on page 19. These are setup codes you must use to set up your remote control.
Batteries are required
Your AllTouch Remote Control has a red light that comes on with each button press when the batteries are good. The light blinks twice when the batteries are installed for the first time. If the batteries are low, the red light blinks twice each time you press a button.
Follow these steps to check the batteries and install new ones if necessary.
1.Press POWER .
Note: If you have not used your remote control in a while, you may have to press POWER several times to make the red light stay on.
| AllTouch® |
| |
| AUX | TV |
|
VCR | POWER | CBL | |
|
| ||
MENU 
INFO
T6051
2.Did the red light stay on?
•If yes, the AllTouch Remote Control batteries are good.
•If no, the batteries are inserted improperly or the voltage is low. If you replace the batteries, use two alkaline AAs.
A
+ | - + | - | |||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
B
C
T6052
573497 Rev B | 3 |
