Close housing lid tightly, then close latch.
7.Do not allow any water droplets to get inside housing. This will cause the inside of the housing to fog.
8.Close housing lid tightly. Make sure there are no obstructions that prevent the housing from closing. Make sure lid is tightly pressed into housing, ( see picture).
9.Close housing latch. Make sure the lid is pressed flat and evenly against the housing body. The housing may leak if the lid is not flat against the housing when closed.
Test camera and housing
1.Press the power button on the upper back side of the housing to turn camera power on.
2.Press the shutter button on the top of the housing to take a test picture.
3.The power or shutter button should have a smooth action and return to its original resting position after pressing. It is normal to feel some resistance when pressing the power and shutter button.
4.Press and hold power button to turn camera power off. It is recommended to leave camera power off until you’re ready to use camera to preserve battery power.
5.After 1 minute the LCD and monitor will turn off, and the camera will in power save mode. To
6.After 3 minutes the camera power will shut down. To operate the camera, push the POWER BUTTON to turn on the camera.
63
