Blade Arbor | 5/8 in. | ||
Blade | Diameter | lOin. | |
Blade | Bevel Angle | 0o _ 90 ° | |
Radial Arm Swing Range 45 ° minimum | left - 90° right | ||
Blade | Height Adjust | 5.35 | in. |
Carriage Travel | 17.25 | in. | |
Cutting | Capacity - Maximum Cross Cut | 15.50 | in. |
Cutting Capacity - Maximum | 26 in. | ||
Bevel Cut
A cut made across a workpiece with the blade at any angle other than 90° to the table surface.
Chamfer
A cut removing a wedge from a block so the end (or part of it) is angled rather than at 90 degrees.
Climb
A hazard in which the blade "climbs" over and out of the workpiece, pulling the stock out of the operator's hands or running across the workpiece.
Compound Cut
A cross cut with both a miter angle and a bevel angle. Cross Cut
A cutting operation with the blade parallel to the carriage arm and the blade teeth pointing down, It can be across or with the grain, normally across the grain or width of the workpiece,
Dado Cut
A
A device to help guide workpieces during rip cuts. Fence
A piece of wood used as a edge guide for the workpiece, Located perpendicular to the carriage arm, Can be placed at different distances from the rear table edge in combination with the other table pieces and is secured with table clamps.
Freehand
Dangerous practice of making a cut without using a fence,
Gum
A sticky,
Alignment of the blade to the fence,
Cutting | Capacity- Maximum | 16in. | |
Depth | of Cut at 90 ° |
| 3 in. |
Depth | of Cut at 45 ° | 2.25 in. | |
Table Size | 40x27x | 1 in. | |
Table Height |
| 36 in. | |
Rating |
| 13.0/6.5 Amperes | |
Input |
| 120V/240V 60 Hz - AC only | |
No Load Speed | 3,450 | RPM | |
Infeed
The side of the blade where the blade teeth point up, opposite the
A type of rip cut in which the blade is between the column and the motor.
Kerf
The space left by the removal of material in a cut or the slot produced by the blade in a
A hazard that can occur when blade binds or stalls, throwing workpiece back toward operator.
Leading End
The end of the workpiece pushed into the cutting tool first.
Miter Cut
A vertical cut made at any angle other than 0° across the workpiece.
Molding
A shaping cut that gives a varied shape to the workpiece and requires a special blade.
A type of rip cut in which the motor is between the blade and the column. (The blade is "outside" the motor.)
Pushstick
A device used to feed the workpiece through the saw blade during cutting operations. It helps keep the operator's hands well away from the blade.
Rabbet
A type of cut that gives a notch in the edge of a workpiece.
Resaw
A cutting operation to reduce the thickness of the workpiece to make thinner pieces.
