Sears 315.220100 Mounting SAW to LEG Stand, Attachung Elevating Handwheel, See Figure

MOUNTING SAW TO LEG STAND

See Figure ! 1.

_ WARNING: Firmly bolt the saw to the leg stand to keep the saw from tipping, walking, or sliding.

[] Locate the following hardware from a small hard- ware bag:

4 hex bolts (5/16-18 x 5/8 in.)

4 Iockwashers (5t16 in.)

8 flat washers (11/32 in.)

4 hex nuts (5/16-18)

[] Place the saw on top of the leg stand so the holes in the saw base line up with the holes on top of the leg stand braces.

[] Put a washer on a screw, and put the screw and washer into the hole in the saw base. Cap with another washer, then a lockwasher and a hex nut. Hand tighten the set.

[] Install the other three sets and securely tighten aft four sets with a 1/2 in. wrench.

SAW

BASE

LEG

STAND

SAWBASE
	HEXBOLT
	SHER
	}HER
	NUT
LEGSTAND	Fig. 11

ATTACHUNG ELEVATING HANDWHEEL

See Figure 12.

WARNING: Be sure the main power cord of your saw is unplugged. Ignoring this precaution

could result in serious injury. Do not perform the following steps unless the saw is unplugged.

The elevating handwheel adjusts the height of the radial arm and the blade.

[] Take the handwheel, star washer, and screw (10-24 x 5/8 in. Soc. Hd.) from the hardware bag.

[] Place the handwheel on the end of the elevating shaft, which extends from the front of the saw base.

[] Place the star washer on the screw and thread screw into the end of the shaft.

[] Securely tighten the screw with a 5/32 in. hex key.

[] Raise or lower the arm by turning the handwheel.

ELEVATING

SHAFT

HANDWHEEL

SCREW

! STARWASHER

23