7 - 6 INPUT TEST
When INPUT TEST is selected, the MONITOR will show the following, allowing you to watch the status of each switch and the value of each V.R.
| INPUT TEST |
HANDLEBAR | OFF |
THROTTLE | OFF |
FRONT BRAKE | OFF |
REAR BRAKE | OFF |
VIEW CHANGE | OFF |
MUSIC SELECT | OFF |
SHIFT UP | OFF |
SHIFT DOWN | OFF |
START | OFF |
COIN #1 | OFF |
OFF | |
OFF |
This test mode displays the status of each switch, button, and Volu me. When the switch/button corrsponds to the name of the item is pressed, if OFF changes to ON, it is satisfactory. When corresponding Volume is operated, if the Volume value differs in a natural manner, it is satisfactory.
APPROPRIATE VALUE OF TENSION VOLUME
Tension volume values are displayed in hexadecimal numer- als within the range of 00H~ffH. If the value does not satisfy the following limitations, adjust the Volumes gear mesh so as to meet the requiremnts.
LOWER LIMIT: Over 05H
UPPER LIMIT: Under faH
PRESS TEST BUTTON TO EXIT
Press the test button to return to the menu mode
FIG. 7.6 INPUT TEST
7 - 7 OUTPUT TEST
| OUTPUT TEST |
|
START | LAMP | OFF |
VIEW CHANGE | LAMP | OFF |
MUSIC SELECT | LAMP | OFF |
RACE READER | LAMP | OFF |
>EXIT
SELECT WITH SERVICE BUTTON
PRESS TEST BUTTON TO EXIT
FIG. 7.7 OUTPUT TEST
Choose OUTPUT TEST to cause the following lower screen to appear. In this test, check the status of each lamp.
Pressing the TEST BUTTON causes “ON” to be displayed and the corresponding lamp lights up. Pressing the TEST BUTTON again cuases “OFF” to be displayed and the lamp goes off. The Foot Controller is locked with the Slide Lock in the ON status, and Unlocked to become free with the Slide Lock in the OFF status.
Press the test Button to return to the MENU MODE.
23
