Seiko 7K32 manual To Preserve the Quality of Your Watch

■NECESSARY PROCEDURE AFTER THE BATTERY CHANGE (RESETTING THE IC)

・After the battery is replaced with a new one, or the watch hands move improperly, follow the procedure below. The built-in IC will be reset and the watch will resume normal operation.

All the stored data will be erased from the memory by following the procedure. For details, refer to “Notes on battery change”.

How to reset the IC

1.Pull out crown “1” to the second click.

2.Press buttons B and C at the same time.

Before using the watch, adjust the time, barometer hands and alarm hands by referring to the corresponding sections of this instruction manual. (Refer to “TIME SETTING”.)

When button C is pressed to adjust the position of the barometer hand “2”, the atmospheric pressure change indicator automatically moves.

Note on the battery change:

It takes 3 hours after the battery is changed or the IC is reset before the watch shows the proper change in the atmospheric pressure by the atmospheric pressure change indicator.

■TO PRESERVE THE QUALITY OF YOUR WATCH

CAUTION

●CARE OF YOUR WATCH

・The case and bracelet touch the skin directly just as underware. If they are left dirty, the edge of a sleeve may be stained with rust of those who have a delicate skin may have a rash.

・After removing the watch from your wrist, wipe perspiration or moisture with a soft cloth. This will prevent the watch from being soiled, adding to the life of the gasket.

<LEATHER BAND>

・When removing moisture from a leather band, do not rub the band with the cloth as this may discolor it or reduce its gloss. Be sure to blot up the moisture using a soft dry cloth.

<METAL BRACELET>

・Clean the watch bracelet with a soft toothbrush dipped in water or soapy water. If your watch is not water-resistant, be careful not to get the case wet when cleaning.

<SOFT PLASTIC BRACELET>

・The bracelet made of soft plastics does not require special care. If it gets dirty, however, it may cause trouble to the skin. Rinse it with soapy water from time to time. Since it is a chemical product, it may deteriorate by the use of solvents. The band will become hardened or discolored after several years of use. In that case, replace it with a new one.

・If your watch is not water-resistant, be careful not to get wet with water or sweat. When it gets wet with water or sweat, wipe it thoroughly dry with a hygroscopic cloth.

・If your watch is 5, 10 or 20 bar water resistant, rinse it in a bowl of fresh water after used in seawater. Do not use chemicals to wash it.

・If your watch has a rotating bezel, clean the bezel regularly. Otherwise, dust will gather under it, making the rotation harder.

85 86