Using the headset system
To start the conference call using the master headset:
Establish a wireless link between headset and base station (the LINK
To add a guest headset to the conference call:
Place the guest headset to be added to the conference call into the base station of the master headset.
The HEADSET LED flashes blue/red and the headset pairs to the base station. If pairing was successful, the HEADSET LED lights up blue.
Take the guest headset out of the base station. You hear a beep in the master headset.
Press the LINK button on the master headset within 15 seconds. The guest headset is enabled for the conference call.
If necessary, repeat this procedure for the two other guest headsets.
4 | Call the other party. |
To exit the conference call with a guest headset:
Press the LINK button on the guest headset.
5 | To end the conference call: |
|
Use the master headset to end the conference call.
The wireless links to all other headsets participating in the conference call are disconnected.
You can only end the conference call using the master headset. Other functions such as volume adjustment and muting the headset’s microphone can still be performed on each headset.
Adjusting the volume
WARNING Hearing damage due to high volumes!
Listening at high volume levels for long periods can lead to permanent hearing defects.
Set the volume to a medium level.
Do not continuously expose yourself to high volumes.
In order to be able to adjust the volume of the ring tone and the acoustic signals, the headset has to be in standby mode. In order to be able to adjust the audio volume, a wireless link has to be established between headset and base station (see page 23).
In PC mode, you can adjust the volume using the AUDIO button or by using the volume control of your operating system (see the instruction manual of your operating system).
29