Using the headset system
Pairing the headset to third party DECT GAP telephones
Place the DW Pro1/Pro2 headset at a maximum distance of 1 m from the third party base station.
Simultaneously press and hold the headset’s LINK button and AUDIO button for 5 seconds.
The headset switches to setting mode/GAP pairing mode and the HEADSET LED flashes blue/red.
Set the third party base station to GAP pairing mode (see the instruc- tion manual of the third party base station).
The headset pairs to the third party base station. If pairing was successful, the HEADSET LED goes off.
The standard code for DW Pro1/Pro2 is “0000”.
Pairing is not successful If pairing is not successful within 60 seconds, the DW Pro1/Pro2 headset switches to standby mode.
For information on how to pair the headset to the third party base station, refer to the instruction manual of the base station.
Charging an additional headset
If you wish to charge an additional headset (headset b) in the base station while you are using your headset (headset a):
Make sure that a wireless link is established between headset a and base station (the LINK LED on the base station lights up blue).
Place haedset b into the base station.
Headset a can continue to connect to and disconnect from the base station and its use is not restricted while headset b is being charged.
If you leave the DECT range
If you leave the DECT range during a call, the audio quality deteriorates. When the link breaks down completely, you hear a descending sequence of beeps in the headset and the LINK LED on the base station lights up red.
To resume the call:
As soon as the headset
Press the LINK button on the headset to resume the call.
If you are using a handset lifter/electronic hook switch or if your softphone supports call control, the call will automatically be ended 60 seconds after leaving the DECT range.
31