Sennheiser EW 300 G2 manual Connecting the amplifier/mixing console, Service interface

Connecting the amplifier/mixing console

The EM 300 G2’s audio outputs are available as an XLR-3M socket and a ¼” (6.3 mm) jack socket , allowing you to simultaneously connect two units (e.g. amplifier, mixing console). The adjusted audio output level is common for both sockets.

Connect the amplifier/mixing console to the XLR-3M socket	or the
¼” (6.3 mm) jack socket .

For detailed information on balanced and unbalanced connection, please refer to the section “onnector assignment” on page 41.

Via the operating menu, adapt the level of the audio output (AF OUT) to the input of the amplifier or mixing console (see “Adjusting the audio output level (EM 300 G2 only)“ on page 31).

Service interface

The service interface is only required for servicing purposes.

19” rack adapter and antenna mount

For mounting one or two receivers into a 19” rack, you require the GA 2 rack adapter (available as an accessory). The GA 2 rack adapter consists of:

y 2 rack mount “ears” y 1 connecting bar y 1 connecting plate

y 2 covering plugs for antenna holes y 12 recessed head screws M 3x6

y2 recessed head screws M 6x10

When mounting only one receiver into a rack, you can use the AM 2 antenna mount (available as an accessory) to mount the transmitter’s antenna connection to the front of the GA 2 rack adapter. The AM 2 antenna mount consists of:

y 2 BNC extension cables (screw-in BNC socket to BNC connector ) y 2 plains washers

y2 nuts

13